PDA

View Full Version : Where to buy a jig for Chewbarka Aluminum GI Tags



Michael Wuensch
12-13-2012, 9:33 PM
Hello All,

Great site here, tons of information!

I am looking for a source of a jig for an Epilog Zing 16 for the Large Chewbarka Aluminum GI Tags.

I know I can make my own, however I am out of town and not able to, I need to be able to send one to my shop.

If anyone could point me in the right direction I would greatly appreciate it.

Thank you so much!

Steve Kelsey
12-13-2012, 10:09 PM
Here is a file in v10 for the outline. It can be cut in any material and then used for holding the tags. I hope it helps.

247858

Kasey Maxwell
12-13-2012, 11:04 PM
here is one that I use.......247862

Michael Wuensch
12-14-2012, 7:28 AM
Thank you for the templates I appreciate it. However I would like one that is already fabricated, if they are available.

Albert Nix
12-14-2012, 8:51 AM
If you have a laser to engrave with, make one. Two pieces of really thick poster board and some double sided tape. You are going to have to lay it all out to match a store bought template anyway??