Question on Monster Hollower

[Jon Finch]

Quick question about the Monster hollowing rig... Can the 5/8" tool bar be used in the 3/4" system for hollow forms with smaller openings?

[John Keeton]

All of the boring bars are milled the same on the male end that goes into the knuckle.

[Roger Chandler]

All of the boring bars are milled the same on the male end that goes into the knuckle.



The tang John mentioned is 5/8".........so the 5/8 inch bar would just slide into the knuckle and you tighten the set screws.

[Jon Finch]

Sweet! You guys are fast. Now I'm off to talk to Santa...

[John M. Smith]

I bought the 3/8" John Jordan bars at Turn On Chicago this year. Monster makes adapters so other sizes can be used too.