View Full Version : Question on Monster Hollower
Jon Finch
12-10-2012, 4:47 PM
Quick question about the Monster hollowing rig... Can the 5/8" tool bar be used in the 3/4" system for hollow forms with smaller openings?
John Keeton
12-10-2012, 4:49 PM
All of the boring bars are milled the same on the male end that goes into the knuckle.
Roger Chandler
12-10-2012, 4:53 PM
All of the boring bars are milled the same on the male end that goes into the knuckle.
The tang John mentioned is 5/8".........so the 5/8 inch bar would just slide into the knuckle and you tighten the set screws.
Jon Finch
12-10-2012, 4:57 PM
Sweet! You guys are fast. Now I'm off to talk to Santa...
John M. Smith
12-10-2012, 7:44 PM
I bought the 3/8" John Jordan bars at Turn On Chicago this year. Monster makes adapters so other sizes can be used too.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.