View Full Version : Vcarve file for simple wooden box
Ernie Martinez
11-20-2012, 1:38 PM
Does anyone have a project file for a simple wooden box project they would be willing to share. I'm looking for something in the 12 x 10 x 4" range.
Thanks
Mick A Martin
11-20-2012, 5:00 PM
Take a look here at the Vectric forum projects, all ready designed and toolpath (always check) with a full how-to documentation http://www.vectric.com/WebSite/Vectric/projects/projects.htm
(http://www.vectric.com/WebSite/Vectric/projects/projects.htm)
David Warkentin
11-20-2012, 5:14 PM
Would be really simple to design something...if I had time.
David Warkentin
11-20-2012, 5:15 PM
What about the paradise box?
Ernie Martinez
11-20-2012, 5:35 PM
I downloaded the paradise box, And I'm going to build it just for fun. I was just looking for a simple box. I guess I could modify the paradise box to my dimensions and get rid of the VCarves. I was hoping for something with dove tails.
Thanks
David Warkentin
11-20-2012, 6:12 PM
Dove tails wouldn't be hard. Do you have an overhang to place your board vertical or how will you get the corners square?
Ernie Martinez
11-20-2012, 6:27 PM
I don't quite follow your question. My machine can cut beyond the front of my table.
David Warkentin
11-20-2012, 9:53 PM
Ok so you will clamp your board out there and cut the pins and tails. Sounds good. Hmmm. Have to think about that a bit. The good news is, I am going to pick my new stinger 1 tomorrow!
Mike Heidrick
11-20-2012, 11:03 PM
Dovetails require vertical clamping otherwise the bit would make a round hole.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.