John Stevenson
11-18-2012, 5:51 AM
Well not really a dongle as it doesn't have one.
The motherboard is the dongle on this software on my machine, problem I have is the computer that runs the laser in the shop is in a limited space and runs a 15" monitor.
I'd like to run Laserworks on my office computer which is away from the shop with large monitor so I can do large sheets with loads of small lettering that need different layers / cutting strategy and see what I'm doing better.
I have installed LW6 on the office computer but it won't boot up as it can't see the mother board.
Obvious answer would be to buy a new motherboard but that seems to be an expensive way round it for a legal product.
Could some files be written to a USB stick that makes it think it's seeing the machine ?
John S.
The motherboard is the dongle on this software on my machine, problem I have is the computer that runs the laser in the shop is in a limited space and runs a 15" monitor.
I'd like to run Laserworks on my office computer which is away from the shop with large monitor so I can do large sheets with loads of small lettering that need different layers / cutting strategy and see what I'm doing better.
I have installed LW6 on the office computer but it won't boot up as it can't see the mother board.
Obvious answer would be to buy a new motherboard but that seems to be an expensive way round it for a legal product.
Could some files be written to a USB stick that makes it think it's seeing the machine ?
John S.