View Full Version : Blum Tandem Jig - Needed?
Bob Cooper
04-21-2005, 11:01 PM
I'm considering using Blum's tandem undermount drawer guides. How useful or necessary is their "Tandem Drilling Jig"? It's about $45. On my next project i may have to install a bunch of these.
Thomas Prondzinski
04-21-2005, 11:21 PM
Bob
I just finished making about 15 drawers with Blum Tandem runners with Blumotion closers. I did not use their drilling jig.Just set the runner on the bottom of the drawer and give it a tap with a hammer to mark the spot for the hole,the front locking devices were slide into the corners and a pilot hole was drilled using the locking device as a template. Or check out Marc Sommerfelds video on cabinetmaking.
Hope this helps Tom
Bob Cooper
04-21-2005, 11:29 PM
Tom:
Thanks...that's good to know. BTW can you give me a pointer to this video?
Bob Cooper
04-21-2005, 11:33 PM
nevermind...found it. I misspelled it the first time. Good video?
John Lucas
04-21-2005, 11:48 PM
Excellent video.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.