TAMI WILSON
11-13-2012, 10:48 AM
Does anyone have a desktop business card holder pattern I can cut out on the laser. I was sort of hoping for one with the tiny dovetail cuts like many of the boxes have.
thanks
Tami
Duncan Crawford
11-13-2012, 2:59 PM
Tami,
This might get you started-- intended for nominal 3mm Baltic birch or equivalent. I set the material thickness at 0.115in, and a 0.004 laser kerf. Saved in CD ver 13 just in case. Top was left flat, so you can trim sides/ends as desired, add personalization, whatever.
duncan
Real Mercier
11-14-2012, 10:08 PM
Here is a basic card holder I typically cut from acryllic. i will also add the customer's logo or whatever added on top. I saved in version 10.0.
I hope it helps.
Real Mercier
245593
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.