Uros Sovilj
11-09-2012, 3:32 AM
Hi
I was just reading a post on backslash settings and decided to test my machine. I never went to details before since i use laser mostly for cutting wood.
I noticed before that line when cutting isn’t perfectly straight but i didn't take attention since i have to sand wood anyway on edges so it didn’t matter.
The problem is with Y lines. If i cut line on Y axis it’s not straight.
I try to go through every possible setting since cleaning and changing the X axis belt didn’t help. Check for any loos screw try to change belt tension on Y and X but still the same.
I really don't know any more what to try. I was also thinking that might be the rails but then the problem will be always at same place but it's not.
245169
Any ideas?
I was just reading a post on backslash settings and decided to test my machine. I never went to details before since i use laser mostly for cutting wood.
I noticed before that line when cutting isn’t perfectly straight but i didn't take attention since i have to sand wood anyway on edges so it didn’t matter.
The problem is with Y lines. If i cut line on Y axis it’s not straight.
I try to go through every possible setting since cleaning and changing the X axis belt didn’t help. Check for any loos screw try to change belt tension on Y and X but still the same.
I really don't know any more what to try. I was also thinking that might be the rails but then the problem will be always at same place but it's not.
245169
Any ideas?