Bob Coleman
10-28-2012, 11:11 PM
Hi All,
I have a Powermatic 15" planer , the older model with the infeed/outfeed roller tables. When I got it, the starter enclosure cover (the plastic one inside the base) was held on by duct tape. Not liking that, I untaped it and went looking for appropriate screws to attach it. The parts list in the manual isn't helpful, and I cannot seem to find the right screw.
Its between M8 and M10, and isn't any flavor of 5/16 or 3/8 I can get at the local hardware store. Can someone who owns one pull off a bolt and measure it for me?
Thanks in advance - this is driving me crazy!
I have a Powermatic 15" planer , the older model with the infeed/outfeed roller tables. When I got it, the starter enclosure cover (the plastic one inside the base) was held on by duct tape. Not liking that, I untaped it and went looking for appropriate screws to attach it. The parts list in the manual isn't helpful, and I cannot seem to find the right screw.
Its between M8 and M10, and isn't any flavor of 5/16 or 3/8 I can get at the local hardware store. Can someone who owns one pull off a bolt and measure it for me?
Thanks in advance - this is driving me crazy!