View Full Version : Red location Dot

Walt Langhans
10-23-2012, 10:21 AM
Hey Guys,

I was wondering, the red location dot is it a 'must have' or a 'nice to have' feature? Thoughts?

Scott Shepherd
10-23-2012, 10:28 AM
Must have.

Chris DeGerolamo
10-23-2012, 10:59 AM
I don't know how else I would be certain of alignment on the "get it done right the first time" projects we do. MUST HAVE.

Mark Sipes
10-23-2012, 10:59 AM
A very nice to have unless you are able to place the cross hairs via the monitor...... worth it in my opinion but again I've never been without it. You can see on the material or plate exactly where the laser will be for placement.

Mike Null
10-23-2012, 12:16 PM
Must have.

Walt Langhans
10-23-2012, 12:20 PM
Thanks guys I will make sure I get one then. Or can I just duct tape on a laser pointer, lol! (and just in case... yes I'm kidding about that)

Mark Ross
10-23-2012, 4:17 PM
I traded my red dot in for a green one...just kidding...it was blue...but seriously, there is no way I would not have one. Too helpful.

Martin Boekers
10-23-2012, 7:18 PM
Hey not just for engraving, but it makes laser alignment sooooooo much easier!

Bill Cunningham
10-25-2012, 9:32 PM
What everyone else said..