Tony Lenkic
10-20-2012, 7:38 PM
I have been running my new Speedy300-60W for 8 days and I have couple of questions for you seasoned veterans.
1 - What settings you use for marking stainless steel with CerMark?
Job control suggestions is 100 power 30 speed and I find that this setting is not optimal as mark is more of grey than rich black I was getting with ULS400-45w. I know I should run grid pattern to find sweet spot.
2 - When job is started and I press pause button, how do I cancel current job from further process?
Thanks in advance.
1 - What settings you use for marking stainless steel with CerMark?
Job control suggestions is 100 power 30 speed and I find that this setting is not optimal as mark is more of grey than rich black I was getting with ULS400-45w. I know I should run grid pattern to find sweet spot.
2 - When job is started and I press pause button, how do I cancel current job from further process?
Thanks in advance.