Sandy Henry
10-08-2012, 7:04 PM
Set up a new Trotec Speedy 300 60w last week. Still in learning curve but I love the job control software!!
Engraving results show thin, horizontal lines extending beyond what should be a clean engraved edge. From distance, it looks kinda like a shadow around all edges. Text looks worse than other graphics. Shows up on painted metal, Romark lasermax colors, & is most obvious on Romark brushed gold & aluminum. Tried enabling & disabling 'High Quality' engraving - same results. Lowered the 'tickle power' & edges got worse. Any suggestions? THANKS! Sandy Henry
Engraving results show thin, horizontal lines extending beyond what should be a clean engraved edge. From distance, it looks kinda like a shadow around all edges. Text looks worse than other graphics. Shows up on painted metal, Romark lasermax colors, & is most obvious on Romark brushed gold & aluminum. Tried enabling & disabling 'High Quality' engraving - same results. Lowered the 'tickle power' & edges got worse. Any suggestions? THANKS! Sandy Henry