View Full Version : A blue flower
joel nucifore
10-04-2012, 3:21 PM
242415242416
something I wanted to give a shot at. Aussie burl dyed with blue trans tint. about 12" tall.
Scott Lux
10-04-2012, 4:49 PM
I'm working on a similar shaped chunk of wood. I hope mine comes out half as nice.
Jim Burr
10-04-2012, 5:55 PM
That one deserves a much better picture Joel!!! I'd really like to get a better look at the dye job.
Joe Meirhaeghe
10-04-2012, 6:42 PM
WOW, Joel I think that 1 1/4" boring bar you got from Advanced lathe tools is a bit over kill for that size of a turning.:eek:
Seriously though glad to see your getting to use your new lathe. Nice work.
Baxter Smith
10-04-2012, 9:14 PM
Nice job Joel! Will 2nd the sharper picture thought.
Steve Schlumpf
10-04-2012, 9:33 PM
I like what I see but agree with Jim - some additional photos would sure be nice! Remember that you can post up to a 1024x 800 pixel photo with a file size of 107 kb.
Fred Belknap
10-04-2012, 10:19 PM
Looks good but kind of gets lost in the background.
Bernie Weishapl
10-04-2012, 10:23 PM
Like the others I like what I can see. Brighter pic's would help.
Curt Fuller
10-04-2012, 10:27 PM
I can tell, even with the not so great photo, that is a beautiful and interesting turning. Very nice!
joel nucifore
10-05-2012, 6:03 AM
Sorry about the pic... but tried, first time with a back ground I do like what it gives a pic. Better than a sheet.. And Joe THE 1 1/4' bar works great on these pc's just a little vibration towards the bottom of the pc.
George Guadiane
10-05-2012, 9:43 AM
I am SOOOOooooo GLAD that you have a lathe, a shop and some wood again to work on!
NICE piece. Keep posting!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.