Stephan Derome
09-28-2012, 1:21 PM
Hi, I am new to the forum.
We have a Trotec Speedy 500 200 watts and we have a an order for cutting pieces of 1/4'' x 23'' x 45''. The material is .250 tickness Extruded Acrylic Green Edge. The problem we have is with the same set-up ( power, speed, ppi, etrc) from one sheet to anothers one the material doesn't cut completely. For some peices we have to go up to 4 pass to cut it. Anybody face that problem? Did is the material that creating the problem? is it our laser?
In the dark
Thanks in advance for any tip or help
We have a Trotec Speedy 500 200 watts and we have a an order for cutting pieces of 1/4'' x 23'' x 45''. The material is .250 tickness Extruded Acrylic Green Edge. The problem we have is with the same set-up ( power, speed, ppi, etrc) from one sheet to anothers one the material doesn't cut completely. For some peices we have to go up to 4 pass to cut it. Anybody face that problem? Did is the material that creating the problem? is it our laser?
In the dark
Thanks in advance for any tip or help