Declan Halpin
09-20-2012, 4:10 PM
Hi all,
I'm just getting my LMI SE225CV setup. I don't have Corel Draw, but I do own Rhinoceros. I have installed it on the laser computer, but can't get it to print to the laser - it just hangs up. Anyone else done this? I assume the driver will recognize that the lines I'm printing are vectors, is that correct?
Thanks in advance,
Declan
I'm just getting my LMI SE225CV setup. I don't have Corel Draw, but I do own Rhinoceros. I have installed it on the laser computer, but can't get it to print to the laser - it just hangs up. Anyone else done this? I assume the driver will recognize that the lines I'm printing are vectors, is that correct?
Thanks in advance,
Declan