George M. Perzel
09-16-2012, 9:43 AM
Hi Guys;
My old GCC Mercury has been a stable stalwart for many years and often used for small jobs. This morning I turned it on-machine initializes fine but when I go to raise the table it moves up a bit and then stops-panel has message which says: Exception Vector 05.
I have never seen this before- Any ideas or inputs welcome.
Best Regards,
George
Laserarts
My old GCC Mercury has been a stable stalwart for many years and often used for small jobs. This morning I turned it on-machine initializes fine but when I go to raise the table it moves up a bit and then stops-panel has message which says: Exception Vector 05.
I have never seen this before- Any ideas or inputs welcome.
Best Regards,
George
Laserarts