larry senen
09-12-2012, 8:32 PM
can someone tell me which one of the two 8" byrd cutter-heads grizzly sells is a 5/8" shaft?
i'm trying to retro fit my 60 powermatic jointer.
ordered the grizzly brand in hope i could just drop it in .no luck of course.
if i have to pull bearings i might as well go with the byrd.
did a site search and found some info but not specific enough.
any advice is welcome.
i'm trying to retro fit my 60 powermatic jointer.
ordered the grizzly brand in hope i could just drop it in .no luck of course.
if i have to pull bearings i might as well go with the byrd.
did a site search and found some info but not specific enough.
any advice is welcome.