Carlos Aveleyra
09-09-2012, 4:39 AM
Hey guys,
I scrapped the idea of using flexisign and decided i would just stick with corel.
Although now i have encountered another problem. I just installed corel X6 after using X5 previously on my GCC 60w spirit GLS and now it is not vector cutting properly.
When it vector cuts, it only scores the material and does not actually cut at the desired power and speed setting.
I am using red as the vector color and black as the engrave color and have no problem engraving. I just don't know why its not doing it this time. I have color management set to off and color setting set to RGB.
I have even tried using other colors. If anyone knows what might fix the problem it would be much appreciated, because i cannot remember for the life of me what i may of done differently to how i had it on x5 as i uninstalled x5 off my laptop i was running it on and so i can't even compare the old settings to manipulate them. >____<
Kind regards,
Carlos.
I scrapped the idea of using flexisign and decided i would just stick with corel.
Although now i have encountered another problem. I just installed corel X6 after using X5 previously on my GCC 60w spirit GLS and now it is not vector cutting properly.
When it vector cuts, it only scores the material and does not actually cut at the desired power and speed setting.
I am using red as the vector color and black as the engrave color and have no problem engraving. I just don't know why its not doing it this time. I have color management set to off and color setting set to RGB.
I have even tried using other colors. If anyone knows what might fix the problem it would be much appreciated, because i cannot remember for the life of me what i may of done differently to how i had it on x5 as i uninstalled x5 off my laptop i was running it on and so i can't even compare the old settings to manipulate them. >____<
Kind regards,
Carlos.