David Fried
04-12-2005, 11:25 PM
My router table came with a box joint jig. I tried to use it last summer but the result wasn't a joint. It seemed using a 6 inch ruler I couldn't get it set up right.
I tried it again the other night with a piece of scrap Oak. The differnce is that now I have a caliper. What a difference!
The box is 3" x 6" x 4". Even though this was just a test I will have to put some hardware on it and find a use for it. It's so small my glasses don't even fit in it!
Now I'll have to find a project where I can really use the jig.
I tried it again the other night with a piece of scrap Oak. The differnce is that now I have a caliper. What a difference!
The box is 3" x 6" x 4". Even though this was just a test I will have to put some hardware on it and find a use for it. It's so small my glasses don't even fit in it!
Now I'll have to find a project where I can really use the jig.