Pete Bejmuk
08-09-2012, 5:59 PM
I just moved my laser from my design studio into my basement. It spent a few days on it's side (bad idea, i know).
Now that it's upright, there is a gap between the engraving table and the part of the left z-axis assembly where the table attaches.
I noticed a screw laying on the floor of the laser itself.
I have a feeling that there should be some circular coupling between the table and the screw assembly.
Here are some pictures of the gap, the attachment point on the screw, and the part where it attaches on the table (my fingers hold the little screw).
http://silvercompassdesigns.com/personal/lasergap-2.jpg
http://silvercompassdesigns.com/personal/lasergap-3.jpg
http://silvercompassdesigns.com/personal/lasergap-1.jpg
Any ideas?
Now that it's upright, there is a gap between the engraving table and the part of the left z-axis assembly where the table attaches.
I noticed a screw laying on the floor of the laser itself.
I have a feeling that there should be some circular coupling between the table and the screw assembly.
Here are some pictures of the gap, the attachment point on the screw, and the part where it attaches on the table (my fingers hold the little screw).
http://silvercompassdesigns.com/personal/lasergap-2.jpg
http://silvercompassdesigns.com/personal/lasergap-3.jpg
http://silvercompassdesigns.com/personal/lasergap-1.jpg
Any ideas?