possible missing part of ULS PS-50 laser - table

[Pete Bejmuk]

I just moved my laser from my design studio into my basement. It spent a few days on it's side (bad idea, i know).

Now that it's upright, there is a gap between the engraving table and the part of the left z-axis assembly where the table attaches.

I noticed a screw laying on the floor of the laser itself.

I have a feeling that there should be some circular coupling between the table and the screw assembly.

Here are some pictures of the gap, the attachment point on the screw, and the part where it attaches on the table (my fingers hold the little screw).

http://silvercompassdesigns.com/personal/lasergap-2.jpg
http://silvercompassdesigns.com/personal/lasergap-3.jpg
http://silvercompassdesigns.com/personal/lasergap-1.jpg

Any ideas?

[Rob Bosworth]

The only part you are missing is one more flat headed cap screw. Remove the bracket from the bottom of the table. Then mount the bracket with two screws to the Z axis Velmex slide. Then re-mount the table brackets to the aluminum table top.