Mark Ross
07-05-2012, 11:30 AM
We run an Epilog 36EXT and ran into a weird one today. It led to a small fire (we caught it in time). Basically we have acrylic, and we vector cut patterns. Today, they fired up a patten that was a few years old. Where a straight line comes to an end and a curve starts, the laser hangs for about 5 seconds. Long enough to cause an issue. Deleting the line and replacing the line doesn't fix the problem. Deleting and redrawing the curve doesn't either. The weird part is that this pattern is also in another file that is multiple patterns and it is rotated. In the multiple pattern file it does not hang. If we select the pattern out of the multiple file and rotate it so that it is straight up and down (we get great panel utilization), we have the issue.
We have ordered Corel X6 to get our softwware up to date, and our print driver and firmware is up to date. Has anyone run into this before? Thanks for the replies.
We have ordered Corel X6 to get our softwware up to date, and our print driver and firmware is up to date. Has anyone run into this before? Thanks for the replies.