PDA

View Full Version : Trying to get my old (Chinese) laser going



ian stewart
07-05-2012, 10:11 AM
Hi

Trying to get my old (Chinese) laser going, think the laser is ok !!??
LG3040 60 Watts (secondhand hybrid) with lasercut 5

having to reinstall software as PC broke
the laser is controlled via a PCI card not USB.
I have the dongle installed
but lasercut says

"plug in Softdog and restart the software"

Anyone any ideas or suggestions


thanks in advance

Rodne Gold
07-05-2012, 12:15 PM
If you really struggling , it might be cheaper/easier to buy a RDLC320 motherboard ($300) and LCD panel ($70) and use Laserworks/Rdcam (no dongle) with it , you can configure it to run the rest of your laser quite easily

Lucy Lee
07-05-2012, 9:01 PM
If your computer is Win7,PCI machine will not comply with win7 system,you may find a XP one to try

Best Regards

Lucy Lee

Adrian Hernandez
07-09-2012, 10:02 AM
Need to make sure that you are installing the drivers correctly I had the same problem once and it had to do with the wrong installation of the drivers. Do need XP operating system