Mohamed Mouncef Aissaoui
06-10-2012, 6:17 PM
Hello
Delighted to be here in this forum that I visit regularly.
With my sincere thanks in advance, I'd like to help me solve my problem.
But I have to say that I have already asked the question on another forum well known since about a month and a half without results. So Sorry.
Here is my problem :
The counter of my chinese laser does not stop after the end of a job and continues counting until I turn off the machine. Meanwhile, to run the next job requires that I press PAUSE and STOP.
I tried to update the HW and FW dozens of times but I can not. It's another issue with this machine.
I reinstalled LaserCt 5.3 and applied the configuration several times but this does not fix the problem.
Report that the beep still works because I hear from other operations. And counter worked normally before.
What should I do?
My machine : XYZ-TECH J6090 100 W, MPC6515, Control Panel PAD03, 4.0.0.1 HW, FW 4.1.2.3, 4.1.2.2 DLL. LaserCut 5.3
Best Regards
Delighted to be here in this forum that I visit regularly.
With my sincere thanks in advance, I'd like to help me solve my problem.
But I have to say that I have already asked the question on another forum well known since about a month and a half without results. So Sorry.
Here is my problem :
The counter of my chinese laser does not stop after the end of a job and continues counting until I turn off the machine. Meanwhile, to run the next job requires that I press PAUSE and STOP.
I tried to update the HW and FW dozens of times but I can not. It's another issue with this machine.
I reinstalled LaserCt 5.3 and applied the configuration several times but this does not fix the problem.
Report that the beep still works because I hear from other operations. And counter worked normally before.
What should I do?
My machine : XYZ-TECH J6090 100 W, MPC6515, Control Panel PAD03, 4.0.0.1 HW, FW 4.1.2.3, 4.1.2.2 DLL. LaserCut 5.3
Best Regards