sal shepherd
06-09-2012, 9:04 PM
Epilog 24X18 , When I engrave in the upper right hand corner say a 3x2x2" rectangle my image is off app 1/8" on x axis to the left. When I engrave thin material 12" x 24" Romark The plunger hits the right hand ruler. How do I calibrate the x axis home? 2nd question when using laser max I use the marble type do you remove the plastic mask? I tried to get a clean burn using epilog settings that I use on my trophy tags with no problem.
The only way I could get a good engraving was to remove the mask and use transfer tape, is this normal?
The only way I could get a good engraving was to remove the mask and use transfer tape, is this normal?