Joe Unni
04-04-2005, 12:05 AM
Hey all,
First I'd like to say "thanks" to all who responded to my earlier request for laminate trimmer recommendations. FYI - I just purchased the PC 97311 this afternoon. It seems to have the most bang for the buck. We'll see if it does what it says it will do.
Here is why I needed the trimmer. The attached photos shows the table that I need to duplicate (actually quadruplicate).
Dimensions are ~ 24 W x 48" L x 30" H
The only requirement other that being completely covered in p-lam is that it be non-metallic (i.e. no nails or screws) except for the casters.
I quoted this job pretty high (something like $1500 per table) hoping NOT to get the job 'cause I really don't like dealing with laminate, but I got it anyway. I still want to do a good job, but I'm a little stuck on how to approach. I'm sure I could figure it out, but I'm looking to you all for some input.
Any and all input is welcome.
Thanks in advance,
-joe
First I'd like to say "thanks" to all who responded to my earlier request for laminate trimmer recommendations. FYI - I just purchased the PC 97311 this afternoon. It seems to have the most bang for the buck. We'll see if it does what it says it will do.
Here is why I needed the trimmer. The attached photos shows the table that I need to duplicate (actually quadruplicate).
Dimensions are ~ 24 W x 48" L x 30" H
The only requirement other that being completely covered in p-lam is that it be non-metallic (i.e. no nails or screws) except for the casters.
I quoted this job pretty high (something like $1500 per table) hoping NOT to get the job 'cause I really don't like dealing with laminate, but I got it anyway. I still want to do a good job, but I'm a little stuck on how to approach. I'm sure I could figure it out, but I'm looking to you all for some input.
Any and all input is welcome.
Thanks in advance,
-joe