I need advise from the experts on which turning tools to keep

[Jeff L Miller]

I have two sets of turning tools with a similar makeup within each set, gouges, parting tools, skews, etc. I really don't know which set is of higher quality, preferred among turners, or a better set in general.

First, the Robert Sorby set, somewhat older with long uniform handles. The second set is Henry Taylor high speed steel232458232459 I don't think the Sorby tools are high speed steel but the Henry Taylor tools are. As you can see, the Taylor chisels are of different length handles though I believe they are a matching set.

My turning abilities are intermediate and I don't turn many bowls or hollow vessels. Mostly handles, knobs, pens, and small decorative items.

Any help is appreciated, I will only keep one of these sets and will be selling the other.

Jeff

[Roger Chandler]

The Henry Taylor set looks to have a heavier tang on them.........for that reason alone, I would keep that set. The Sorby set looks like a cheaper set that I have not seen before.........most Sorby tools are pretty good quality, but these have flat tangs that fit into the handles...........makes me a bit skiddish for heavy cuts!

[Rick Markham]

If you know the Sorby tools are high carbon steel, and the Henry Taylor tools are HSS, I'd keep the Henry Taylor set. If they are both HSS, I'd use both and figure out which ones I liked better. Just my $.02

[Scott Hackler]

I would definitely keep the Taylors if they are HSS. Better steel and they'll hold an edge longer.

[Wally Dickerman]

No contest! H Taylor high speed steel are the keepers. Those Sorby carbon steel tools are quite old. With those handles they are pre-1980. When the bowl gouge came on the market around 1979 or 80, Sorby made some in carbon steel but soon discontinued them.

I suggest that you keep some of the Sorby tools. The flat scrapers can be re-shaped for special needs tools. I have a set of Greenlee Carbon steel tools that I bought in the 50's. I use several of them as small special use scrapers. They don't hold an edge for very long but they work for their intended use.

Respect your Elders

[Steve Schlumpf]

I'm not an expert ... but I would keep the Taylors for the same reason the others have mentioned... HSS.

[Sid Matheny]

If it were me I would keep both so I could have different grinds on similar tools. Just MHO.

Sid

[Thom Sturgill]

If you are set on selling one, keep the Taylors. If you don't need to sell then by all means keep both and use the Sorbys as as scrapers and/or bench chisels.

[Jamie Donaldson]

Since the Sorbys are most likely carbon steel I doubt they will find much of a market for selling. As Wally said, they are an old style handle, and include a continental gouge seldom seen these days. A few like that gouge can be users, so I would keep them for your ever growing tool collection! And Wally, my first set of tools were also Greenlees!

[David DeCristoforo]

The Henry Taylor tools are the better quality tools. But, as Wally and Jamie have pointed out, the Sorby tools are not going to sell for enough to allow you to retire and concentrate on your turning. I have this exact same set of tools and most of them have been "repurposed". The steel is mild enough to allow reshaping with a belt sander or any grinding wheel. You might be better off to keep them against the day you need a "special" shape...

[Bill Wyko]

I'm all about keeping tools. That wqy I could have a sharp tool ready and waiting in the wings.

[Jeff L Miller]

Thanks guys, just what I was looking for. I'll keep the Henry Taylors and If I can find the room, the Sorby's as well.

I appreciate the advice.

Jeff