Gabe Gat
05-16-2012, 7:12 PM
ULS-P50
50W. Laser
It would appear that all of the sudden I'm no longer able to cut through the most basic woods at any of the settings i've mastered over time. I'm trying to cut 1/8 wood and even jacking the laser up to 100% power 2 % speed i'm not making it all the way through the wood. I'm usually able to do it @ 80% power 3% speed no problem. after messing around for hours and trying to figure out what's up I can tell you that the beam is not crisp at all four corners of the table, the further away from the source (bottom right corner) the worse it gets, it gets pretty wide down and fuzzy down there. I'd say there's a solid 1/8" difference between the top left and bottom left of the bed based on my focus tool. Does anyone have any experience with this type of issue?
How does one go about leveling the table? or is it a border issue that i'm missing, i would have though that if it was just a leveling issue I would at least be able to cut a 1" diameter circle at the top left corner, focusing right where that cut was but even that doesn't really seem to be working.
Ideas? Thanks for taking your time to read this.
50W. Laser
It would appear that all of the sudden I'm no longer able to cut through the most basic woods at any of the settings i've mastered over time. I'm trying to cut 1/8 wood and even jacking the laser up to 100% power 2 % speed i'm not making it all the way through the wood. I'm usually able to do it @ 80% power 3% speed no problem. after messing around for hours and trying to figure out what's up I can tell you that the beam is not crisp at all four corners of the table, the further away from the source (bottom right corner) the worse it gets, it gets pretty wide down and fuzzy down there. I'd say there's a solid 1/8" difference between the top left and bottom left of the bed based on my focus tool. Does anyone have any experience with this type of issue?
How does one go about leveling the table? or is it a border issue that i'm missing, i would have though that if it was just a leveling issue I would at least be able to cut a 1" diameter circle at the top left corner, focusing right where that cut was but even that doesn't really seem to be working.
Ideas? Thanks for taking your time to read this.