Steve Ash
03-31-2005, 2:46 PM
A few weeks ago I got a unifence (a partial Valentines day gift from my better half) and someone asked to give a report on how it went together. My computer has been down since then and I am using the local library computer, so I am sorry not answering sooner. The installation was very easy, I attached it to my Delta contractors saw. The only glitch was my own fault, it says to set the measuring tape at "O" which I thought was even with the saw blade. It actually lines up with the cast iron edge of the saw table. The whole installation process may have taken 2 hours max. It sure is a very nice addition to my table saw.:cool: