Club

[Joe Landon]

Mahogany hollow form turned using the lost wood process. Carved and hammered textured with a satin acrylic finish. All comments and critiques are welcomed and appreciated.

230513230514230515230516230517

[Mike Cruz]

Joe, I honestly don't know what to make of it. It IS cool. I just don't know what to make of it...

[Roger Chandler]

Different! Looks like the halves are hollowed separately and put back together.............skilled work at any rate.

[Sid Matheny]

I'm at a loss for words on this one Joe!

Sid

[Jon Nuckles]

Joe, You make the most creative pieces, and the work is always first rate! Nice job.

Roger, I recall Joe posting about his lost wood process in the past and I believe he creates a hollow form and then cuts a section out of the middle and glues the 2 outside pieces back together. He obviously did a lot of carving afterward on this one.

[Russell Eaton]

Joe, that is another very cool turning. Thanks for showing.

[Steve Schlumpf]

Very different! Almost a seashell effect! How big is the piece?

[Joe Landon]

230553


This is the center 1/3 of the original hollow form that was "lost."

[Tim Rinehart]

230553


This is the center 1/3 of the original hollow form that was "lost."
That's what I was wanting to see Joe! You should explain to folks a little about the "lost wood" process...it's kinda cool from what I've been able to see.
Your "club" came out well...though I can't figure out meaning of club. Seems more like a "pod"...but it's your piece and you made something pretty cool using this process!