Mike DeRegnaucourt
04-21-2012, 3:28 PM
Hello,
I am running CorelDraw X5 on Windows 7 (64-bit). I have a large template that I created quite awhile ago (prior to Windows 7 and installing the new Epilog Driver). The dimensions of the template are 24.125" Horizontal X 23.937" Vertical. The problem I am now having under this new driver is that when I try entering the actual dimensions of my template, the darn Epilog driver rounds them up to 24.13 and 23.94 respectively. Normally this should not make too huge of a difference but this template is very detailed for holding a large number of parts to engrave. This rounding up of the page size slightly shifts the engraving locations.
Does anybody know how to get the Epilog Driver to keep the exact dimensions entered and NOT round them up?
This has been so frustrating!
I am running CorelDraw X5 on Windows 7 (64-bit). I have a large template that I created quite awhile ago (prior to Windows 7 and installing the new Epilog Driver). The dimensions of the template are 24.125" Horizontal X 23.937" Vertical. The problem I am now having under this new driver is that when I try entering the actual dimensions of my template, the darn Epilog driver rounds them up to 24.13 and 23.94 respectively. Normally this should not make too huge of a difference but this template is very detailed for holding a large number of parts to engrave. This rounding up of the page size slightly shifts the engraving locations.
Does anybody know how to get the Epilog Driver to keep the exact dimensions entered and NOT round them up?
This has been so frustrating!