john banks
04-15-2012, 8:49 AM
1. How to change date on RDCAM v5 board?
2. Using the 24VDC "wind" output through a relay, the air assist solenoid works well. However, I used another relay to switch the exhaust fan and that also works but I want a delay on turn off otherwise the smoke doesn't clear at the end of a smokey job. I didn't get a time delay relay board because I thought the close delay under the layer properties would do it, but testing it requires "laser through mode" to be selected and this produces a continous laser beam throughout the job so not what I want. Any alternative in software? Otherwise I will get a delay off relay board and set it for 5-10s.
2. Using the 24VDC "wind" output through a relay, the air assist solenoid works well. However, I used another relay to switch the exhaust fan and that also works but I want a delay on turn off otherwise the smoke doesn't clear at the end of a smokey job. I didn't get a time delay relay board because I thought the close delay under the layer properties would do it, but testing it requires "laser through mode" to be selected and this produces a continous laser beam throughout the job so not what I want. Any alternative in software? Otherwise I will get a delay off relay board and set it for 5-10s.