pinnacle 30 watt m series table stuck

[shawn miniaci]

i moved the table as far as it could go down and now it wont go back up. i managed to take the belt off and manualy move the table up some. the down contol works fine when i press the up button it like skips for a second or two like you can hear the motor but thats about it. i checked the auto focus and thats not it, the laser has very low hours .

[Gary Hair]

If you have it turned off you should be able to move the belt by hand and raise the table. It's likely below the lower limit switch and just stuck on the leadscrews. Once you get it above the switch then turn it back on and try to raise it again while pushing up on the table, it will probably work. After all that, get some white lithium grease and lube the leadscrews, it will do wonders!

Gary