View Full Version : Dewalt Biscuit Joiner Blade
Mike OMelia
03-14-2012, 11:27 AM
I need a blade for my Dewalt biscuit joiner, and was wondering if I should go for the expensive Dewalt blade, or get the CMT blade (6 or 8 tooth?)
http://www.amazon.com/s/ref=nb_sb_ss_i_5_12?url=search-alias%3Daps&field-keywords=dewalt+biscuit+joiner+blade&sprefix=dewalt+biscu%2Caps%2C162
Opinions?
Thanks, Mike
Paul Johnstone
03-14-2012, 12:33 PM
I have the 8 tooth CMT biscuit blade for my Porter cable biscuit cutter. I really like it. I think it's better than the Original blade. I imagine the dewalt CMT blade is the same high quality.
Gary Curtis
03-14-2012, 7:35 PM
Highland Hardware sells BJ cutter blades. The same make will fit a DeWalt or even a Lamello Jointers. And I think they sell cutters made by Amana and by CMT. They all do the same jog and are sized the same. Highland can explain this to you over the phone.
Bruce Wrenn
03-14-2012, 9:54 PM
Have it sharpened! Costs only about ten bucks at Dynamic Saw.
Mike OMelia
04-09-2012, 10:05 AM
Highland Hardware sells BJ cutter blades. The same make will fit a DeWalt or even a Lamello Jointers. And I think they sell cutters made by Amana and by CMT. They all do the same jog and are sized the same. Highland can explain this to you over the phone.
Just curious. I'm pretty sure my Dewalt is a 7/8" arbor. That is 0.0875". Lots of the blades have 22mm arbors (0.0866"). Are these interchangeable?
Mike
James White
04-09-2012, 6:22 PM
I rarely use my Dewalt BJ. So I was not willing to spend $50 for a replacement blade. When I discovered that my local HF had one for $8 when using a 20% off coupon. I figured I would give it a shot. To my delight it works just as good as the original.
http://www.harborfreight.com/carbide-tip-plate-joiner-replacement-blade-38840.html
James
Bob Wingard
04-09-2012, 9:55 PM
Have it sharpened ... if the shop removes a bit of carbide from the face, it will actually make the biscuits a better (tighter) fit in the slots.
Mike OMelia
04-10-2012, 9:32 AM
Same here. Think I will give it a try.
Tnx!
Mike
I rarely use my Dewalt BJ. So I was not willing to spend $50 for a replacement blade. When I discovered that my local HF had one for $8 when using a 20% off coupon. I figured I would give it a shot. To my delight it works just as good as the original.
http://www.harborfreight.com/carbide-tip-plate-joiner-replacement-blade-38840.html
James
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.