View Full Version : Pilot Hole Size
Jerry Lawrence
03-12-2012, 10:01 PM
Not sure if this is the right section for this question, so if it should be elsewhere, admin. please feel free to relocate it...thanks!
I'm looking for the right size drill bit to make pilot holes to hold #18 escutcheon pins in cocobolo. The coco. is only 1/2" thick and the holes will be within 3/16" from the edge, so hoping to prevent cracking but still have holes small enough to hold the pins tightly.
Thanks in advance for your help!
Sam Murdoch
03-12-2012, 10:46 PM
This is a case for trying some holes near the edge of a scrap piece - replicating just what you intend to do. You will learn all you need to know. We? Just guessing otherwise.
Jerry Lawrence
03-14-2012, 1:00 AM
That would work, was just hoping I could find the right size first so I could buy the right size the first time and not have to buy a bunch of different size tiny drill bits that I would probably never have another use for. Thanks for the reply!
John Coloccia
03-14-2012, 8:30 AM
#18 is .049. You're 3/16" from the edge of Cocobolo, so I think the odds of splitting it are VERY high. I would drill a pilot for .049 and glue in the pins with a drop of epoxy or superglue. That's 1.25mm (.0492"), btw, if you're searching for the bit online.
You could try for a standard interference fit, maybe 3/64" (.0469") or even #56(.0465"). I would probably normally do #56 or #57(.0430") depending on the kind of wood for a typical situation, but I do believe that even 3/64" will be risky in this case. You might get away with it.
Jerry Lawrence
03-15-2012, 12:24 AM
Thanks, John, for your very informative and very helpful answer!
Tim Howell
03-15-2012, 3:48 AM
http://www.jamestowndistributors.com/userportal/show_product.do?pid=1943
Gauge
Shank Diameter (inch)
Head Diameter (inch)
#18
0.049
0.098
#16
0.065
0.136
#14
0.083
0.177
Metal:
Brass
MET / STD:
Standard
Type:
Nails
Fastener Type:
Escutcheon Pin
These are the drill number sizes in the range you are working with.
60
0.04
59
0.041
58
0.042
57
0.043
56
0.0465
3/64
0.0469
1.25
0.0492
55
0.052
You might try a drop of crazy glue on the pin. ? Don't force the drill - it will flex and walk or wander and give you a crooked hole.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.