Raymond Fries
03-09-2012, 11:00 PM
I bought a Jet xacta saw with 50” rails from a fellow creeker. I need to purchase a mobile base for this saw. Here is where I need some advise. I want to make a storage cabinet on rollers that could tuck away under the extension table; preferable this cabinet would span the full width of the extension table. The mobile extension part # 708158 is attached to the mobile base on the saw in the middle; this accessory would also prohibit the cabinet spanning the full width of the extension table. The reviews on Amazon.com for the mobile part for the extension table (708158) says it is flimsy. Flimsy is not would what I would expect from Jet for $129.
Is there any reason why I need this? I will not be moving the saw that much. But if needed, could I just detach the extension table, move the saw, and reconnect it? This would allow the roller cabinet I was planning to make to span the full width of the extension table.
If the extension table really needs to stay attached o the saw, is the Jet accessory OK or are there other recommendations? Does anyone have the 708158 extension?
Any xacta saw owners out there that could provide advise?
Thanks
Is there any reason why I need this? I will not be moving the saw that much. But if needed, could I just detach the extension table, move the saw, and reconnect it? This would allow the roller cabinet I was planning to make to span the full width of the extension table.
If the extension table really needs to stay attached o the saw, is the Jet accessory OK or are there other recommendations? Does anyone have the 708158 extension?
Any xacta saw owners out there that could provide advise?
Thanks