Jacob Burke
02-28-2012, 5:03 PM
I have a plastic wall plate that I want to engrave. It says that it it is made from Nylon 6. From previous experiences I have learned that some plastics will emit chlorine gas when lasered. Is Nylon 6 ok to laser, or will it emit Cholrine gas or any other poisonous gasses? I have attached the PDF about the plates from the company. Any help is appreciated. Thanks for your help.
-Jacob
This is the Url to the site. The pdf for the plate is the first one listed after the pictures of the plates,entitled: "TradeMaster Thermoplastic Nylon Wall Plates, SF2501R1"
-Jacob
This is the Url to the site. The pdf for the plate is the first one listed after the pictures of the plates,entitled: "TradeMaster Thermoplastic Nylon Wall Plates, SF2501R1"