View Full Version : looking for an imperial config file for a 100 watt under lasercut 5.3

stan kern
02-26-2012, 6:29 PM
I am looking for an imperial config file for a 100 watt chinese laser under win7 lasercut 5.3 i switched to windows 7 last week
now when i engrave the font is all messed up,in fact the smaller the font is gets unreadable.
Could anyone help with this file its very small in fact the metric one i have is fine but i prefer imperial

Vicki Rivrud
02-26-2012, 7:06 PM
Hi Stan,
Over at the Chinese Laser Forum, one of our members is offering the a "working" WIN 7 driver by PM. I'm not sure if it is 32 or 64 bit.

Leetro developed Lasercut based on Windows XP and has not updated it to VISTA or Win 7 as of yet.

Hope that helps,

stan kern
02-27-2012, 2:24 PM
thank you i will have a look but where is the chinese forum ,is it a title here

Gary Hair
02-27-2012, 3:03 PM
it's in her post, right above her name.


stan kern
02-27-2012, 5:05 PM
thanks i saw that but the word dot through me off ...thanks again