Kreg miter guage out of square

[Nelson Bradley]

I searched the forum and was unable to find any thing on this. I managed to knock my kreg miter guage off the table and now it is out of square. Is there a way to square it back up aside from using the nylon screws behind the fence?

[Kevin Gregoire]

which kreg miter gauge do you have?

all the miter gauges i have i use a handy little tool named 'Miterset' http://miterset.home.comcast.net/~miterset/index.html (http://miterset.home.comcast.net/%7Emiterset/index.html)
to set them correctly.

just go over to Dick's site and get one ordered. low price, awesome tool!

http://miterset.home.comcast.net/%7Emiterset/images/fig_3-pins-at-00.jpg http://miterset.home.comcast.net/%7Emiterset/images/fig_4-Gauge-at-90.jpg

http://miterset.home.comcast.net/%7Emiterset/images/fig_6-35.jpg

[John A langley]

Thank you Kevin - The miter set works great. Now when you post the site where I can get the electric mallot

[frank shic]

that's brilliance, kevin. had no idea that device existed! now to find an electric hammer...

[John A Walker]

Yep. That's a good idea.
It would save me risking damage to my Starrett Engineers' square. :rolleyes:

But of course, no matter how accurately you set the mitre guide, you won't get an accurate cut unless the mitre-guide channel and the saw blade are parallel to each other.

Jon Boy