Puffy triangle and square

[Randy Walker]

Hi every one
I have a request for a cut-out that is a symmetrical puffy triangle and a square. Both must fit inside a 5 inch circle and have a 2 inch hole in the middle. It is proving to be more difficult than I had thought it would be. I would appreciate it if anyone could give me a hand or tell me what I’m doing wrong. The graphic below is what I have come up with so far but it is not symmetrical and I cant get the hole to find center. These will be used for some kind of a tool guide so they must be pretty close.

Thanks
Randy Walker

[Steve Kelsey]

Something like this? I left the my layout stuff there so you can see how I did it. I don't know if you want to round the corners or not, but that should just be adding a small circle at the right point and trimming out what you don't need.

I used a 3 point curve to draw the lines for the triangle.

-Steve

[Howard Garner]

Here is my attempt.
The secret is that the circle in the puffy triangle is not in the center of the triangle, but offset.
223500

[Randy Walker]

Thanks Steve and Howard. That was exactly what I needed. Thank you so much. I never thought of using the 3 point curve I used the arc tool.


Randy Walker