PDA

View Full Version : Help with Pinnacle Laser



Vince Williams
02-10-2012, 12:12 PM
I am having problems getting an engravin job from my computer to the engraver. Have replaced all cables and seems to be transmitting fine, the machine is not recieveing it or does not show that it is.. Any suggestions. Thanks for any and all assistance in advance.. Lone Wolf Engraving.:confused:

Mark Sipes
02-10-2012, 12:50 PM
Before the cables were replaced... were there any other problems with the computer...upgrades, configuration, new hardware..etc.

The last job that ran......... no problems.....same day as problem started. Then you replaced all cables on the outside of the machine.

Have you reset all cables and card insde the machine....? Can you hook up a different computer?

Age of machine... Warranty?

Scott Challoner
02-10-2012, 3:42 PM
Are you sure you're printing to your laser and not another printer? Been there, done that.