William Long
02-05-2012, 11:43 AM
So I've seen this guy years ago with a long ponytail at the trade shows showing off the Leigh D4R Dovetail Jig. I also believed I've taken a class from him at Highland Hardware in Atlanta on the jig years ago. He had his Leigh D4R Dovetail Jig on a box he built with two side areas to hold his routers w/ bits. It was a pretty simple design with a box and then two areas for the routers with slots cut out to allow the spinning bits to slow down by themselves.
I need to build that box. I can come up with something close but I was wondering if anyone has seen this and any pictures or plans for this type of holder.
I need to build that box. I can come up with something close but I was wondering if anyone has seen this and any pictures or plans for this type of holder.