View Full Version : Grizzly G1035 shaper question
keith micinski
01-27-2012, 3:11 PM
Is there a way to use regular half inch shank router bits with this shaper or do you have to buy special shaper cutters?
Cary Falk
01-27-2012, 3:17 PM
http://www.grizzly.com/products/Bit-Spindle-for-G1035/G1705
keith micinski
01-27-2012, 4:11 PM
Thanks Cary. This is making it real hard to turn down this shaper I found. I was kind of hoping there wasn't a way to make regular bits work.
Cary Falk
01-27-2012, 4:28 PM
Sorry Keith. I will tell you what I tell my family, " If you are not prepared the answer, don't ask the question." :D
Dave Wagner
01-27-2012, 5:10 PM
Yes, regular router bits work pretty good with the correct collet/adapter. I have the G1026 and use the the router adapter all the time. I do have regular shaper/cutters too.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.