View Full Version : taper jig again
Mike Stanton
03-16-2005, 10:52 PM
. I am using pnresizer and the picture comes out there program. Not my picture.
I am going to make a light house and wanted to use a jig like the one here. Will it come out right if I tilt the blade to 30 dergees. Mike
Mike Stanton
03-16-2005, 10:55 PM
.It puts a picture of there software When I look at the picture on my desk top it is my picture I want to post. On onother site it works right Why? Mike
Bill Arnold
03-17-2005, 6:48 AM
This site posts whatever picture you upload, just like other sites. Be sure to check the filename you're choosing.
Regards,
Ken Salisbury
03-17-2005, 6:56 AM
There is a detailed description on how to post photos in this thread:
http://www.sawmillcreek.org/showthread.php?p=132416#post132416
http://www.oldrebelworkshop.com/misc/moderator.gif
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.