Leveling Table on Epilog Legend 24TT

[John Edgerton]

Looking for some help on a problem with leveling the table on my Epilog 24TT. I contacted Epilog and got their help on using the leveling screws (and lock screws) located at the four corners of the table. The issue now is that while the table is level side to side, it's not level front to back. The front is low but the leveling screws are maxed out for lifting the table. By low, I mean that the front is about 3/16" lower than the back of the table. Any ideas on next steps? I plan to call Epilog again but I would appreciate any help, and second opinions, from folks on this site.

Many thanks.

John

[Bruce Clumpner]

Have you tried starting at the front of the table, pushing your level down all the way and adjusting the back of the table to compensate? Has worked for me in the past.

[John Edgerton]

Bruce,

You nailed it. I lowered the table at all four corners as you suggested and started the process of leveling from there. It actually needed just a little adjustment once I took the former adjustments out. Many thanks!

John