John Edgerton
01-23-2012, 10:01 PM
Looking for some help on a problem with leveling the table on my Epilog 24TT. I contacted Epilog and got their help on using the leveling screws (and lock screws) located at the four corners of the table. The issue now is that while the table is level side to side, it's not level front to back. The front is low but the leveling screws are maxed out for lifting the table. By low, I mean that the front is about 3/16" lower than the back of the table. Any ideas on next steps? I plan to call Epilog again but I would appreciate any help, and second opinions, from folks on this site.
Many thanks.
John
Many thanks.
John