PDA

View Full Version : Cut out flames



Joe Kace
01-20-2012, 6:59 PM
Hey everybody..

I have this order for a led lit sign and the customer is looking for the top edge to be cut with a flame design. I have looked for something comparable that I could use as a starting point but no luck and I am no artist. Does someone have a file for something like this they would like to share. The edge length is 2 ft.

thanks in advance

Joe

Mike Null
01-20-2012, 7:36 PM
Joe

If you're using CorelDraw there are probably some in your art files.

I just checked X3 and there are about 20 flame files there.

Bruce Clumpner
01-20-2012, 7:42 PM
Here's something that might work....It tiles pretty well for longer edges

Joe Kace
01-20-2012, 7:45 PM
Mike,
Where do I look in Corel? I didn't even know they had art files.

Joe

Mike Null
01-20-2012, 7:51 PM
Joe

You should have received several discs depending on which version you have. Normally your clip art files are on number 2 or 3 as well as your font files. Photos are usually on the last disc.

In X3 the clip art is on 2.

Joe Kace
01-20-2012, 7:55 PM
Hi Mike,

I just located them on disk 2. I thought about this when you mentioned but I never booted those other disks. I didn't see anything but it looks like Bruce has something that will work.

Thanks
Joe

Joe Kace
01-20-2012, 8:12 PM
Hi Bruce,

I owe you one, those are perfect.

Thanks a lot

Joe

Bruce Clumpner
01-21-2012, 3:05 AM
Don't forget to show everyone what you've done


Hi Mike,

I just located them on disk 2. I thought about this when you mentioned but I never booted those other disks. I didn't see anything but it looks like Bruce has something that will work.

Thanks
Joe

Joe Kace
01-21-2012, 7:13 AM
I would, but I don't think it's suitable to show on this forum. I'm not exactly excited about the wording on this job but money is money and it's not going in my home.

Joe

Mike Null
01-21-2012, 8:25 AM
Joe

Here's a look at some of the files on the cd.