Larry Palanuk
01-06-2012, 12:21 PM
I had a fun Christmas break building a router table.
I bought the Bench Dog cast iron top and built the table with aluminum extrusion I had from a scrapped commercial tool. My Christmas gift from my wife was the router lifter.
218494
218497
Dust collection is out of the back. I have the router tied into my automated dust collection, so it turns on and off by itself.
The task light on top is also automated. Turns on with the router and I have a delay for the off. Not that I am too lazy to turn a light on, but is was free, and 24VDC. Since my logic controller and gates run on 24VDC, I just ran a wire back to the control panel and wired into the controller.
218496
Router bits are stored on the side door.
218495
I bought the Bench Dog cast iron top and built the table with aluminum extrusion I had from a scrapped commercial tool. My Christmas gift from my wife was the router lifter.
218494
218497
Dust collection is out of the back. I have the router tied into my automated dust collection, so it turns on and off by itself.
The task light on top is also automated. Turns on with the router and I have a delay for the off. Not that I am too lazy to turn a light on, but is was free, and 24VDC. Since my logic controller and gates run on 24VDC, I just ran a wire back to the control panel and wired into the controller.
218496
Router bits are stored on the side door.
218495