Y axis needs adjustment

[tony mazzone]

I have an Epilog 24tt. The Y-axis is off by about 3/16". If I send something to print it always prints too high. I've tried changing the settings but it does not seem to do anything. If I try to adjust the mirror the beam goes off center the farther away that it gets. I must have screwed something up but can't figure out what it is. Any ideas?

Thanks,

Tony

[Glen Monaghan]

You can mechanically adjust the rulers or you can electronically (through the control panel) adjust the X and Y home positions. Full description is in the manual, which you can get as a PDF from epilog's site if you don't have a copy.

-Glen

[Dan Hintz]

If the beam gets off center the farther it gets from the origin, you need to re-align it. If the entire axis is off by that amount, either adjust the rulers appropriately, or possibly even the limit switch.