HTC Outfeed Roller Table for PM2000

[Joe Leigh]

Just got done installing a new outfeed roller table for my PM200 and I thought I'd post a few pics...

It took about 2 hours to install and setup. Nothing tricky, the install was very straightforward. The manufacturer supplies you with a template and the instructions were clear and concise.


http://i137.photobucket.com/albums/q226/lj61673/DSCN2171.jpg


http://i137.photobucket.com/albums/q226/lj61673/DSCN2172.jpg


Here is a pic of the table folded down when not in use..


http://i137.photobucket.com/albums/q226/lj61673/DSCN2170.jpg

This model has been modified to fit the new PM200 and SawStop models. The lower support bracket has an adjustable arm so its height can be adjusted as to not interfere with your dust collection fitting

http://i137.photobucket.com/albums/q226/lj61673/DSCN2174.jpg


http://i137.photobucket.com/albums/q226/lj61673/DSCN2173.jpg

All in all it was a clean install and it works as advertised with a simple mechanism to raise and lower the table. This unit is made by HTC and sold by Grizzly for $289 plus shipping. Worth every penny in my opinion...

[Van Huskey]

Very nice install. With the built in mobile base on the PM2000 it makes for a very tidy mobile package when the table is dropped.